2 Stroke 63CC Gas Powered Post Hole Digger Auger Borer Fence Drill & 4″/6″/8″ Bits

About This Item

The auger is ideal for quickly drilling into the earth in order to set into the ground: fence posts, poles, trees, shrubs etc.

Equipped with a 63cc gasoline engine, the auger can be handled by one or two people easily for a wide variety of tasks.

Ergonomically designed, it is accurate, easy to use and economical.

Supplied with bits of 4″, 6″ & 8″, the auger can drill holes of various diameters.

With this tool, you will be able to perform professional quality work.

The Earth Auger has a straight through gearbox, unlike models with a side mounted engine, the straight through design is much more robust and less likely to shear gears.

Technical Details:

Engine: Single Cylinder, 2-stroke, air-cooled

Cylinder capacity :63cc

Fuel mix: 25/1

Bits : 4″, 6″ and 8″

Bit length : 31″

Safety: Bit Lock

Power:3.2kw

Carburetor with pump

Easy starting system (cord starter). Centrifugal clutch

Change bits quickly and easily

Weight : 10.85 Kg. (without bit)

Accessories:

3 bits: 4″, 6″ and 8″

Extension Bar: 12″

Start steps:

1. Please remember to close the air door and then pull the starter (don鈥檛 forget this step, otherwise you will not be able to ignite when you deadlift)

2. Pull the rope starter 3-5 times, the total length of the rope is 70cm, and the safety distance is 30-50cm. If the safety distance is exceeded, the rope will be broken, not the longer the rope is, the better

3. After the start is successful, remember to open the damper (not to pull the starter when opening the damper. When the damper is opened, too much air enters and there is too little oxygen, it is difficult to start, so pull the starter when the damper is closed.After the machine starts successfully, open the damper銆

4.Pulling the starter to the end of 70cm will break the rope; the safety distance is 30-50cm, and pulling the rope hard will cause the rope to break. After breaking, you need to buy the starter again.

Reminder:

The gas tank of the pit digger has a vent hole. If the oil is filled too much during use, the oil will spray out from the hole. It is recommended to fill 1/3 full.

• Equipped with 4, 6 and 8 inch screws that allow drilling holes of different diameters.

• Ergonomic, precise, easy to use and economical design.

• Equipped with a 63 cc gasoline engine, it can easily handle one or two people to perform different tasks.

• The snail is an ideal tool for quickly drilling into the ground and fixing it to the ground: fence posts, posts, trees, bushes, etc.

• Compared to models with side-mounted engines, the Bulldozer has a continuous gearbox. The pitch gear is more robust and it is impossible for it to cut gears.

Specifications